L-Bracket Assembly Only
The flat bottom of the L-Bracket is a large 2.3 x 3.4 inches with five holes for mounting to a variety of surfaces
Center pivot hole is 3/8-inch (9.5 mm)
The four screw holes are 11/64-inch (4.5 mm..
This prism series is ideal for deformation and mining surveys or wherever permanent mounting is needed
This design makes mounting and pointing easy on uneven surfaces
Mounting arm allows tilt up to 240 degrees and prism mount allows 360 degrees..
This prism series is ideal for deformation and mining surveys or wherever permanent mounting is needed
This design makes mounting and pointing easy on uneven surfaces
Mounting arm allows tilt up to 240 degrees and prism mount allows 360 degrees..
Rain Hood helps keep the prism clean to ensure continual measurements over a long measuring cycle
Other components like the L-Bracket Assembly (#6603-00-050) and the 5/8 x 11 or M8 adapter (#6603-00-051 or #6603-01-051) are available..
The Walleye™ Prism System accommodates a full size 62 mm prism for long range applications or when a larger prism is needed
Rain hood helps keep the prism clean to ensure continual measurements over a long measuring cycle
Components av..
The Walleye™ Prism System accommodates a full size 62 mm prism for long range applications or when a larger prism is needed
Rain hood helps keep the prism clean to ensure continual measurements over a long measuring cycle
Compo..
This is the sticky Notification module. You can use it for any sticky messages such as cookie notices, special promotions, or any other important messages. http://www.allaboutcookies.org/