QUANTITY LIMITED: This product has been discontinued
Wedge-shaped aluminum plate features a 12.5 mm prism
Plate can be fixed with special adhesive on to the pavement
Dimensions: 10 x 10 x 2 cm (3.94 x 3.94 x 0.79 inches)
Weighs 0.62 lb (0.28 ..
This SECO Mini Prism is ideal for deformation surveys, mining surveys, or where permanent mounting is needed
Design makes mounting and pointing simple
Features a black anodized aluminum holder
The 25 mm copper-coated pris..
This SECO Mini Prism is ideal for deformation surveys, mining surveys, or where permanent mounting is needed
Design makes mounting and pointing simple
Features a black anodized aluminum holder
The 25 mm silver-coated pris..
The Adjustable Dual Prism is the newest addition to our 6603-Series for mining, tunneling, monitoring and rail
Minimal horizontal angle is 84° (Hex tool included)
Prism holder is machined from 303 stainless-steel
Holders ..
Flat top
Pressure-cast from solid brass
Can be hand-stamped in the field
1 3/8" (34.925 mm) - 2 1/2" (63.5mm) diameter head
Features a 2" (50.8mm) ribbed cross section shank for staying power and Weigprevents marker from turning or loosening
..
Dome top
Pressure-cast from solid brass
Can be hand-stamped in the field
1 3/8" (34.925 mm) - 2 1/2" (63.5mm) diameter head
Features a 2" (50.8mm) ribbed cross section shank for staying power and Weigprevents marker from turning or loosening
..
Anodized aluminum plate
The three bottom anchor bolts are embedded in concrete during installation
With 5/8 x 11 threaded stud for Tribrach adapter centered on the plate
Weighs 2.29 lb (1.04 kg)
..
L-Bracket Assembly Only
The flat bottom of the L-Bracket is a large 2.3 x 3.4 inches with five holes for mounting to a variety of surfaces
Center pivot hole is 3/8-inch (9.5 mm)
The four screw holes are 11/64-inch (4.5 mm..
This prism series is ideal for deformation and mining surveys or wherever permanent mounting is needed
This design makes mounting and pointing easy on uneven surfaces
Mounting arm allows tilt up to 240 degrees and prism mount allows 360 degrees..
This prism series is ideal for deformation and mining surveys or wherever permanent mounting is needed
This design makes mounting and pointing easy on uneven surfaces
Mounting arm allows tilt up to 240 degrees and prism mount allows 360 degrees..
Rain Hood helps keep the prism clean to ensure continual measurements over a long measuring cycle
Other components like the L-Bracket Assembly (#6603-00-050) and the 5/8 x 11 or M8 adapter (#6603-00-051 or #6603-01-051) are available..
Measures 3/4 x 9.9 inches (19.05 x 251.46 mm)
Features a hex bolt used to hammer the bolt in to the surface
Once installed, remove the hex bolt and install #6601-03
Comes with M8 thread patterns
Weighs 1.25 lb (0...
This is the sticky Notification module. You can use it for any sticky messages such as cookie notices, special promotions, or any other important messages. http://www.allaboutcookies.org/